Strip: Acrylates Copolymer, Polyurethane-11, Dipentaerythrityl Pentaacrylate, Acrylates Crosspolymer, Polyester-5, Synthetic Fluorophlogopite, Polyethylene Terephthalate, Polyurethane-33, Aluminum Hydroxide, Tin Oxide.

MAY CONTAIN: Chromium Oxide Green, Iron Oxides, Red 36, Manganese Violent, Blue 1 Lake, Titanium Dioxide, Aluminum Powder.

Prep Pad: Isopropyl Alcohol, Water/Aqua/Eau

HOW TO APPLY:

STEP 1: PREP

• Wash nails with soap and water.
• Shape nails and push back cuticles.
• Use enclosed Prep Pad to ensure nails are clear from oils and residue.
• Make sure your nails are completely dry before application.

STEP 2: SELECT SIZE

• Curve the sheet over each nail to find the best fit. Size down if in between sizes!
• Remove the protective film. Gently lift the strip from the sheet, starting from the edge.
• Place the strip over the center of your nail, starting atr the cuticle line and smoothing outward.
• For optimal adhesion, the strip should be placed above the cuticle line, avoiding skin.
• Press down firmly from the center, then side to side.

NOTE: GLAZE may become stiff in colder temperatures. Once it is brought to room temperature, it will become flexible again for use. Strips can be warmed up between your hands before application.

STEP 3: TRIM

• Trim the strip flush to your nails using nail scissors or nail clippers.
• Make sure the strip does not exceed your nail length. • Any overhand will cause lifting, chipping, or cracking.

STEP 4: CURE & FILE

• Press & hold the button on the back of the lamp for at least 1 second to power on.
• Cure under the Mini LED Lamp (sold separately) for 60 seconds.
• Position the nail file horizontally along your free edge.
• File firmly across your free edge in one direction to remove excess.

HOW TO REMOVE:

STEP 1: REMOVE

• Apply Magic Off+ or cuticle oil on nail bed.

STEP 2: LIFT

• Use manicure stick to gently and slowly lift nail strip from corner of the cuticle area.
• Gradually push the strip off your nail.

PRO TIP: Spend an extra minute smoothing and pressing down the strip; the more you press = the better the adhesion.

PRO TIP: Using the manicure stick, gently and thoroughly press down on the strip to seal all edges before curing. This will prevent hair and debris from catching onto the nail strip perimeter.

PRO TIP: Be sure not to expose unused strips to LED light while curing manicure. If GLAZE is exposed to light, it will cure itself and will become unusable. Store in Glaze container while lamp is in use.

PRO TIP: For optimal adhesion, avoid exposing nails to lotions, oils, or water for at least one hour after application.

WARNING: Flammable. Avoid direct or close contact to flame or extreme heat. Keep away from direct sunlight. Keep out of reach of children.